Two quantities that are often confused
Cooling capacity describes the rate at which heat can be removed. Electrical power input describes the rate at which electricity is consumed. Both may be expressed in kilowatts, so the label matters. A unit with 3.5 kW cooling capacity does not necessarily draw 3.5 kW of electrical power.
BTU per hour is another unit of heat-transfer rate. One kilowatt of cooling is approximately 3,412 BTU/h. A nominal 12,000 BTU/h unit therefore corresponds to roughly 3.52 kW of cooling capacity. This conversion is arithmetic, not a recommendation that the unit is suitable for a particular room.
Capacity is not a floor-area promise
A room's cooling load includes heat through the building envelope, solar gains, people, equipment and incoming air. Ceiling height, glazing, shade and occupancy all matter. An installer should assess the relevant conditions rather than simply multiply the floor area by a universal number.
Oversizing can create control and comfort problems as well as unnecessary purchase cost. Undersizing can leave equipment unable to meet the load. Variable-capacity equipment can modulate within a range, but that range is not unlimited and does not remove the need for sizing.
Read ratings in context
Capacity and efficiency are measured under specified test conditions. Performance can change with indoor and outdoor temperatures, pipe arrangements and installation quality. Ask for manufacturer data relevant to the expected conditions. A brochure maximum or turbo-mode claim should not be treated as continuous normal operation.
A supplier may use horsepower language as a market category. Ask for the actual rated cooling capacity and input power rather than trying to design a room around a horsepower label. The same informal category may not identify an identical performance range across products.
Original label-reading example
Imagine two fictional models each provide 3.5 kW of cooling at the stated test condition. Model A draws 1.0 kW and Model B draws 1.2 kW. Their simple cooling-to-input ratios at that point are 3.5 and about 2.92. The example does not compare their seasonal performance, comfort, reliability or actual consumption in a particular Zimbabwean building.
If Model A averaged 0.7 kW input over a five-hour period, the energy used would be 3.5 kWh. The rated cooling output should not be substituted into that calculation.
Questions for the sizing discussion
Keep the calculation and equipment data with the quotation. A technically meaningful specification is more useful than an unsupported claim that a certain BTU size always covers a certain number of square metres.
- What design indoor condition and outdoor condition were assumed?
- How were windows, roof, occupants and equipment treated?
- Is the proposed unit's minimum and maximum capacity appropriate?
- What airflow and distribution limitations affect the room?
- Is heat gain reducible through shading or insulation first?
Sources & further reading
Use these references to check the underlying guidance and any current local requirements. Practical worksheets and illustrative examples in this guide are original educational material.
- Natural Resources Canada: air conditioning your home and cooling-load assessment
- ENERGY STAR: room air conditioners and sizing
- US Department of Energy: consumer guide to home heating and cooling
This guide is general information. Source notes are not a claim of independent professional review.